📏 M120 Bluetooth probe

Step 0: let Hermes see what your Mileseey M120 sends over Bluetooth.

Before you start
  1. Fully close ImageMeter (swipe it away), because the laser only talks to one app at a time.
  2. Set the laser to metres / mm, switch it on and turn its Bluetooth on.
  3. Use Chrome on the Razr.
1 · Connect
Status: not connected
2 · Take readings
  1. Press measure on the laser. Each reading it sends shows up below.
  2. After each one, type exactly what the laser screen shows (e.g. 1.234) and tap ➕.
  3. Do about 5 readings: a short one (~0.5 m), a long one (~3 m+), and the same spot twice.
—
3 · Send the log to Hermes

Then paste it into the Hermes chat (or email it to yourself and drop the file in).

Log

  


  

    
Didn't work? (only if asked)

    
If it connects but finds no services, add the service UUID from nRF Connect here and connect again.